Commercial
Chiller Installation & Maintenance
A chiller is the quiet machine that everything else depends on. When it stops, the building warms up or the process stops, and neither is a small problem on a Monday morning.
We install, repair and maintain air-cooled chillers serving buildings and processes: small commercial premises, clinics, bakeries, butcheries and light industrial units. That includes chilled water and glycol systems, pumps, buffer tanks and the controls that decide when the machine runs.
Most chiller problems are not mysterious. A condenser that has not been cleaned in two years cannot reject heat, so the machine runs at high pressure and cuts out. Low flow from a failing pump or a blocked strainer trips a safety. A chilled water setpoint gets changed during a heatwave and never changed back. Because a chiller is expensive to replace and cheap to look after, we push maintenance rather than repairs: condenser cleaning, water condition, flow checks, safety controls and a short written record of each visit.
Heat rejection is the whole job
An air-cooled chiller sitting in a hot, dusty or enclosed plant area will underperform no matter how good the machine is. Condenser condition is where we start.
Flow, water and controls
Strainers, pumps, water quality and setpoints. Most trips we are called to are one of those four, not a failed compressor.
Scheduled, not reactive
A chiller on a service schedule is a known cost. A chiller that fails in December is an emergency with a production line attached to it.
What the work includes
- Air-cooled chiller supply and installation
- Process cooling and glycol system work
- Chiller repairs: compressors, controls, pumps, sensors
- Condenser and evaporator cleaning
- Water condition, strainer and flow checks
- Planned maintenance with a written visit record
When to call us
- The chiller runs but does not reach setpoint
- Frequent high-pressure or low-flow trips
- The building is warm on the floors furthest from the plant
- Water on the floor or a leaking pump seal
- A chiller that has never had a maintenance visit
Questions
Chillers, answered
How often should a chiller be serviced?
Twice a year for a small air-cooled machine in a clean position, quarterly where there is dust, flour or grease in the air. Condenser cleaning is the single most important item.
Our chiller trips in hot weather. Why?
Usually condenser condition or airflow, sometimes low refrigerant charge. High ambient temperatures expose a problem that has been building for months.
Can you take over maintenance from another contractor?
Yes. We will ask for the service history if it exists, do a baseline survey, and tell you what state the machine is actually in rather than what the logbook claims.
Do you work on small process chillers?
Yes, including the compact units used in butcheries and bakeries. They are usually neglected because they are out of sight, which is exactly why they fail at the worst time.
Related services
Commercial HVAC & Maintenance
Rooftop units, ducted systems and split plant maintained on a schedule, with filters and coils that actually get checked.
Read moreCold Room Installation & Repairs
Walk-in chillers designed, built, repaired and serviced, from a small back-room unit to a full commercial room.
Read moreFreezer Room Installation & Repairs
Below-zero rooms built and repaired properly, with the drainage, defrost and alarms that keep a full room from thawing.
Read moreEdgemead, Monte Vista & Bothasig
Tell us what is happening in the room.
A call or a WhatsApp message with the symptom and the address is usually enough for us to tell you what kind of visit this is.
Enquiry tagged: Chiller Installation & Maintenance · Edgemead